SNOW REMOVER POWER UNIT
Product Description
The power unit is specially designed for various trucks to increase different types of snowboards,Hydraulic Power Unit For Car, provide lifting and left-right swing functions for the snowboards,Hydraulic Lifter Remover, and can also choose different rings and different valves.Electric Hydraulic Valve For Tractor.
Model specification
| Type model | Motor motor |
Pump displacement t pump displacement (cc / r)
|
Tank capacity y Fuel tank volume (L)
|
pressure Pressure (MPa)
|
installation Installation method
| Oil port size |
| H PU1-60ADAG AH AFE（S）A | DC12V1.6KW 2500转 | 1.3 | 3.5 | 1.8 | 卧式 | G1 / 4“（可定制或自定义） |
| H PU1-60BFAHBH AFE（S）A | DC24V 2.2千瓦2700rpm | 1.6 |
Special Note
1. For pumps with different flow rates, pressure and motor power, please check the order guide.
2. The motor is based on the gap working system S2 = 2 ~ 4min (continuous working time), so it cannot run continuously.
3. Before installation, the cylinder, tubing, joints and Other hydraulic components must be cleaned and free of any impurities.
4. The viscosity of hydraulic oil should be 15-68cst, and it should be clean and free of impurities. It is recommended to use HM46 hydraulic oil.
5. After the system runs for the first time, immediately check whether there is enough oil in the oil tank.
6. The hydraulic oil should be replaced in the first 100 hours after the system is used, and then every 3,000 hours thereafter.
7.Car Lift Hydraulic Power Unit
Contact us if you need more details on Stanley Hydraulic Power Unit. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Ground Power Unit in Aircraft Hydraulic、International Harvester Power Unit. If these products fail to match your need, please contact us and we would like to provide relevant information.Product Categories : Old Products